Hyper-V Appliance

You could check the official Hyper-V VM Creation here at

Create a virtual machine in Hyper-VMicrosoftLearn

1. Follow the steps below on Hyper-V Manager to install a new VM using the image downloaded from the PBI Private Access Appliance section

1. Follow the onscreen steps below to provide the following details for Name, Location, Generation, Memory and Networking

1. Upload the disk you had downloaded from PBI Private access Appliance section

1. Complete the setup

1. After the VM is created, follow the below steps to finalize the setup by going to the setting section of your VM

1. Disable Secure Boot in the Security settings

1. Update the required set of processors per your organizational needs

1. Start your VM from the previous screen

1. wait for the appliance to change status from NOT CONFIGURED to RUNNING

1. Copy the IPV4 value and access the appliance web page and continue the registration process