Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Loading...
Parallels Client for Linux network settings can be specified using the configuration file, which can be found at the following location:
~/.config/2X/Client/parallelssettings
The settings are user specific. If a Linux machine is used by multiple users, each user needs to modify his/her own file.
The settings can be specified using the following format:
[SETTING]=[VALUE]
Example:
KA_ENABLE=0
This section describes parameters that can be used in the parallelssettings
configuration file.
Enable or disable the network keep-alive option. Sends network probes to detect if the network connection is alive.
Value: 1 (Enabled) or 0 (Disabled)
Default: 1 (Enabled)
Example:
Disable network probing:
KA_ENABLE=0
Specifies the idle time before the keep-alive network probing is initiated. Depends on the KA_ENABLE
option being enabled.
Value: Time in seconds.
Default: 5 seconds
Example:
Set the idle time to 10 seconds:
KA_MAXIDLE=10
Specifies the number of keep-alive probes to send before closing the connection. Depends on the KA_ENABLE
option being enabled.
Value: An integer greater than 0.
Default: 3
Example:
Set the number of probes to 6:
KA_COUNT=6
Specifies the time period during which the transmitted data may remain unacknowledged before the connection is closed. This option is only supported on Linux kernel v2.6.37 and later.
Value: Time in milliseconds
Default: 9000 milliseconds (9 seconds)
Example:
Set the time period to 10 seconds.
USER_TIMEOUT=10000
Specifies the idle time between sending keep-alive network probes. Depends on the KA_ENABLE
option being enabled.
Value: Time in seconds.
Default: 2 seconds
Example:
Set the idle time to 4 seconds:
KA_INTERVAL=4