Managing a single user session from the command line

The following Parallels Client for Windows parameters are available when launching published application and published desktop in a single client session from the command line.

Parameters	Note
s!='primary server'	Primary Server hostname or IP address.
b!='backup server'	Secondary Server hostname or IP address.
a!='application/desktop id'	Published Application/Desktop ID.
p!='override application params'
t!='port'	Port of the Parallels RAS server connection.
u!='username'	Username for the user to connect with.
q!='password'	Password for the user.
d!='domain' ignored if user name is in UPN format	Domain name.
l!='0/1' 0 use primary server, 1 user backup server	Specify value in order to connect either to primary or backup server.
m!='connection mode' (gateway mode = 0, direct mode 1, gateway ssl mode = 2, direct ssl = 3, direct rdp=4)	Specify value for the connection mode.
o!='0/1' if set to 1 credentials are overwritten with SSO information if available	When set to 1, credentials are overwritten with SSO credentials.
i!='connection alias'	Specify a connection Alias.
c!	Always ask for credentials.
r!	Reconnect if connection is dropped .

Example

1. In Command Prompt, go to the location were Parallels Client is installed and run the following command:

   TSClient.exe s!='2008ad1.2x.testing' a!='#50' t!='80' d!='2x.testing' u!='testerjm'q!='123456'  m!='0'

Running the above command will launch Published application with ID92, for user testerjm.