Managing a single user session from the command line
The following Parallels Client for Windows parameters are available when launching published application and published desktop in a single client session from the command line.
Parameters
Note
s!='primary server'
Primary Server hostname or IP address.
b!='backup server'
Secondary Server hostname or IP address.
a!='application/desktop id'
Published Application/Desktop ID.
p!='override application params'
t!='port'
Port of the Parallels RAS server connection.
u!='username'
Username for the user to connect with.
q!='password'
Password for the user.
d!='domain' ignored if user name is in UPN format
Domain name.
l!='0/1' 0 use primary server, 1 user backup server
Specify value in order to connect either to primary or backup server.
m!='connection mode' (gateway mode = 0, direct mode 1, gateway ssl mode = 2, direct ssl = 3, direct rdp=4)
Specify value for the connection mode.
o!='0/1' if set to 1 credentials are overwritten with SSO information if available
When set to 1, credentials are overwritten with SSO credentials.
i!='connection alias'
Specify a connection Alias.
c!
Always ask for credentials.
r!
Reconnect if connection is dropped .
Example
In Command Prompt, go to the location were Parallels Client is installed and run the following command:
Running the above command will launch Published application with ID92, for user testerjm.
Last updated